The MR2 Owner's Club of New Zealand

I need to replace my slipping clutch and while researching this have found there may be issues with getting the SMT to relearn clutch operation.The spyder manual I have found on this forum only covers manual transmissions and has no information on SMT. Does anyone have any information on this? If so please email me on [email protected]

You can use any clutch on the SMT as on the manual.
The important thing is that the clutch fork ends up in the same position as it is on the factory setup (i.e. approx 50mm from the clutch solenoid housing). You will also need to perform the "relearn" procedure using Techstream software plugged into the car's OBD port.