Clutch replacement on 2003 SMT Needing information?
Moderator: Moderators
Forum rules
This area is dedicated to technical discussions concerning ZZW30's a.k.a. MRS / Spyder. Please try to spell correctly because this will help people find information later if they are using search functionality. If you need assistance with your car and want to host a spanner day, please use the appropriate section of the forum: http://mr2.org.nz/phpbb3/viewforum.php?f=35 Thank you.
This area is dedicated to technical discussions concerning ZZW30's a.k.a. MRS / Spyder. Please try to spell correctly because this will help people find information later if they are using search functionality. If you need assistance with your car and want to host a spanner day, please use the appropriate section of the forum: http://mr2.org.nz/phpbb3/viewforum.php?f=35 Thank you.
-
Rosscar
- Club Member - MR2OCNZ
- Posts: 50
- Joined: Wed Feb 17, 2016 12:46 pm
- Stomping Ground: Manawatu
- Prime Mover: ZZW30 (MRS / Spyder)
- First name: Ross
Clutch replacement on 2003 SMT Needing information?
I need to replace my slipping clutch and while researching this have found there may be issues with getting the SMT to relearn clutch operation.The spyder manual I have found on this forum only covers manual transmissions and has no information on SMT. Does anyone have any information on this? If so please email me on [email protected]
-
psyguy
- Club Member - MR2OCNZ
- Posts: 355
- Joined: Mon Oct 24, 2016 8:25 pm
- Stomping Ground: Auckland
- Prime Mover: ZZW30 (MRS / Spyder)
- First name: Ivor
Re: Clutch replacement on 2003 SMT Needing information?
You can use any clutch on the SMT as on the manual.
The important thing is that the clutch fork ends up in the same position as it is on the factory setup (i.e. approx 50mm from the clutch solenoid housing). You will also need to perform the "relearn" procedure using Techstream software plugged into the car's OBD port.
The important thing is that the clutch fork ends up in the same position as it is on the factory setup (i.e. approx 50mm from the clutch solenoid housing). You will also need to perform the "relearn" procedure using Techstream software plugged into the car's OBD port.